Siemens SINUMERIK 828D Operating Manual page 442

Programming technology functions (cycles)
9.4 Milling
Parameter Description
Position (only for
•
ShopTurn)
•
•
•
Clamp/release spindle (only for end face Y/peripheral surface Y)
The function must be set up by the machine manufacturer.
(only for ShopTurn)
The positions refer to the reference point:
X0 Reference point X
Y0 Reference point Y
Z0 Reference point Z
(only for G code)
Face C: The positions refer to the reference point:
X0 or L0 Reference point X or reference point length polar
Y0 or C0 Reference point Y or reference point angle polar
Z0 (only for Shop- Reference point Z
Turn)
Face Y: The positions refer to the reference point:
CP Positioning angle for machining area
X0 or L0 Reference point X or reference point length polar
Y0 or C0 Reference point Y or reference point angle polar
Z0 (only for Shop- Reference point Z
Turn)
Peripheral surface C: The positions refer to the reference point:
Y0 or C0 Reference point Y or reference point length polar
Z0 Reference point Z
X0 Cylinder diameter ∅
(only for ShopTurn)
Peripheral surface Y: The positions refer to the reference point:
C0 Positioning angle for machining surface
Y0 Reference point Y
Z0 Reference point Z
X0 Reference point X
(only for ShopTurn)
W Pocket width
L Pocket length
R Corner radius
Z1 Depth referred to Z0 (inc) or pocket depth (abs) - (only for ∇, ∇∇∇ or ∇∇∇ edge)
442
At the front (face)
At the rear (face)
Outside (peripheral surface)
Inside (peripheral surface)
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
mm
mm
mm
mm
mm or
degrees
mm
Degrees
mm
mm or
degrees
mm
mm or de-
grees
mm
mm
Degrees
mm
mm
mm
mm
mm
mm
mm
Turning