Insert Wait Marks - Siemens SINUMERIK 828D Operating Manual

10.2.8

Insert WAIT marks

To synchronize programs via several channels, you have the option of inserting WAIT
marks.
In the wait mark you define the type, and depending on the synchronizing command, the
number and the channels to be synchronized.
WAIT marks
In the "WAIT mark" window, the following synchronizing commands are available:
Type
WAITM
WAITMC
WAITE
SETM
CLEARM
Note
Inserting WAIT marks in additional programs
Using the "Copy" and "Paste" softkeys, you have the option to insert the blocks with WAIT
marks into other programs for other channels.
Procedure
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Meaning
Sets a mark and waits for the specified channels (with exact stop)
Sets a mark and waits for the specified channels (without exact stop)
Waits for the end of program of the specified channels (current channel not
specified)
Note: Numbers or variables cannot be entered.
Sets a mark
Note: Channels cannot be entered
Clear mark in own channel
Note: Channels cannot be entered.
1. The multi-channel program has been created.
2. Place the cursor at the location of the program where you want to set
the WAIT mark.
3. Press the "Various", "Continue", and "WAIT mark" softkeys.
The "WAIT mark" window is opened.
4. In the "Type" selection box, select the desired WAIT mark.
5. If necessary, in the entry field, enter the desired number.
6. In the associated selection field of a channel, select "Yes" if the WAIT
mark for this channel is to be valid.
Multi-channel machining
10.2 Multi-channel support
643