Siemens SINUMERIK 828D Operating Manual page 653

Note
Search target via "Search pointer"
The "Search Pointer" window is displayed - as usual - over the complete lower part of the
screen. The upper contents of the window remain multi-channel.
The actual channel is displayed in the title bar of the "Search Pointer" window.
The "Delete search pointer" also only acts on this channel.
Note
Search target via "Search text"
If, for a block search, you approach the program position using "Search text", please note
that a search is only made in the selected channel column.
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
5. Press the "Start search" softkey.
The search starts.
All channels of the group are started corresponding to the search
mode that has been set.
During the block search, the search states are displayed in a
message window (e.g. "Block search running").
You receive a message if the search target has been reached - or
an error message if the search target was not found.
Multi-channel machining
10.2 Multi-channel support
653