Siemens SINUMERIK 828D Operating Manual page 344

Programming technology functions (cycles)
9.1 Drilling
Parameter
Position
(only for ShopTurn)
X0
Y0
α0
(only for G Code)
Z0
X0
Y0
α0
(only for ShopTurn)
Z0
CP
X0
Y0
α0
(only for ShopTurn)
X0
Y0
Z0
α0
(only for ShopTurn)
X0
C0
Y0
Z0
α0
(only for ShopTurn)
344
Description
At the front (face)
•
At the rear (face)
•
Outside (peripheral surface)
•
Inside (peripheral surface)
•
X coordinate of the reference point X (abs)
This position must be programmed absolutely in the 1st call.
Y coordinate of the reference point Y (abs)
This position must be programmed absolutely in the 1st call.
Angle of rotation of the line referred to the X axis
Positive angle: Line is rotated counter-clockwise.
Negative angle: Line is rotated clockwise.
Face C:
Z coordinate of the reference point (abs)
X coordinate of the reference point – first position (abs)
Y coordinate of the reference point – first position (abs)
Angle of rotation of line in relation to the X axis
Positive angle: Line is rotated counter-clockwise.
Negative angle: Line is rotated clockwise.
Face Y:
Z coordinate of the reference point (abs)
Positioning angle for machining area
X coordinate of the reference point – first position (abs)
Y coordinate of the reference point – first position (abs)
Angle of rotation of line in relation to the X axis
Positive angle: Line is rotated counter-clockwise.
Negative angle: Line is rotated clockwise.
Peripheral surface C:
Cylinder diameter ∅ (abs)
Y coordinate of the reference point – first position (abs)
Z coordinate of the reference point – first position (abs)
Angle of rotation of line with reference to Y axis
Positive angle: Line is rotated counter-clockwise.
Negative angle: Line is rotated clockwise.
Peripheral surface Y:
X coordinate of the reference point (abs)
Positioning angle for machining surface
Y coordinate of the reference point – first position (abs)
Z coordinate of the reference point – first position (abs)
Angle of rotation of line with reference to Y axis
Positive angle: Line is rotated counter-clockwise.
Negative angle: Line is rotated clockwise.
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Unit
mm
mm
Degrees
mm
mm
mm
Degrees
mm
Degrees
mm
mm
Degrees
mm
mm
mm
Degrees
mm
Degrees
mm
mm
Degrees
Turning