Siemens SINUMERIK 828D Operating Manual page 549

Parameter
Machining
surface
(only for ShopTurn)
(only for ShopTurn)
Machining
Z0
Z1
CP
C0
DXY
DZ
UXY
UZ
Lift mode
FS
ZFS
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Description
Face C
•
Face Y
•
Face B
•
Peripheral surface C
•
Peripheral surface Y
•
Clamp/release spindle (only for end face Y/B and peripheral surface Y)
The function must be set up by the machine manufacturer.
The following machining operations can be selected:
∇ (roughing)
•
∇∇∇ base (base finishing)
•
∇∇∇ edge (edge finishing)
•
Chamfering
•
Reference point in tool axis Z
Pocket depth (abs) or depth referred to Z0 or X0 (inc)
Positioning angle for machining area
- (only for ShopTurn, machining surface, face Y)
Positioning angle for machining surface
- (only for ShopTurn, machining surface, peripheral surface Y)
Maximum plane infeed
•
Maximum plane infeed as a percentage of the milling cutter diameter
•
- (only for ∇ and ∇∇∇ base)
Maximum depth infeed
– (only for ∇ or ∇∇∇ edge)
Finishing allowance, plane
– (only for ∇, ∇∇∇ base or ∇∇∇ edge)
Finishing allowance, depth
– (only for ∇ or ∇∇∇ base)
Lift mode before new infeed
If the machining operation requires several points of insertion, the retraction height
can be programmed:
To retraction plane
•
Z0 + safety clearance
•
When making the transition to the next insertion point, the tool returns to this
height. If there are no elements larger than Z0 (X0) in the pocket area, then Z0
(X0) + safety clearance can be programmed as the lift mode.
Chamfer width for chamfering - (only for chamfering machining)
Insertion depth of tool tip (abs or inc) - (for chamfering machining only)
Programming technology functions (cycles)
9.5 Contour milling
Unit
mm
mm
Degrees
Degrees
mm
%
mm
mm
mm
mm
mm
mm
mm
mm
549