Siemens SINUMERIK 828D Operating Manual page 477
Computerized numerical controller for machine tools
Hide thumbs
Also See for SINUMERIK 828D:
- Function manual (1799 pages) ,
- Commissioning manual (1167 pages) ,
- Programming manual (822 pages)
Table of Contents
Advertisement
Parameter
Machining
position
X0
Y0
Z0
(only for G code)
X0 or L0
Y0 or C0
Z0
(only for ShopTurn)
CP
X0 or L0
Y0 or C0
Z0
(only for ShopTurn)
Y0 or C0
Z0
X0
(only for ShopTurn)
C0
Y0
Z0
X0
(only for ShopTurn)
W
L
α0
Z1
DXY
(only ShopTurn)
DZ
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Description
Single position
•
Mill rectangular pocket at the programmed position (X0, Y0, Z0).
Position pattern
•
Position with MCALL
The positions refer to the reference point:
Reference point X – (only for single position)
Reference point Y – (only for single position)
Reference point Z
Face C: The positions refer to the reference point:
Reference point X or reference point length polar – (only for single position)
Reference point Y or reference point angle polar – (only for single position)
Reference point Z – (only for single position)
Face Y: The positions refer to the reference point:
Positioning angle for machining area – (only single position)
Reference point X or reference point length polar – (only for single position)
Reference point Y or reference point angle polar - (only for single position)
Reference point Z - (only for single position)
Peripheral surface C: The positions refer to the reference point:
Reference point Y or reference point angle polar - (only for single position)
Reference point Z - (only for single position)
Cylinder diameter ∅ – (only for single position)
Peripheral surface Y: The positions refer to the reference point:
Positioning angle for machining surface – (only for single position)
Reference point Y – (only for single position)
Reference point Z – (only for single position)
Reference point X – (only for single position)
Slot width
Slot length
Angle of rotation of slot
Face: α0 refers to the X axis or to the position of C0 with a polar reference point
Peripheral surface: α0 refers to the Y axis
Slot depth (abs) or depth relative to Z0 or X0 (inc) - (only for ∇ and ∇∇∇)
Maximum plane infeed
•
Maximum plane infeed as a percentage of the milling cutter diameter
•
- (only for ∇ and ∇∇∇)
Maximum depth infeed - (only for ∇, ∇∇∇ and ∇∇∇ edge)
Programming technology functions (cycles)
9.4 Milling
Unit
mm
mm
mm
mm
mm or de-
grees
mm
Degrees
mm
mm or de-
grees
mm
mm or de-
grees
mm
mm
Degrees
mm
mm
mm
mm
mm
Degrees
mm
mm
%
mm
477
Advertisement
Table of Contents
