Siemens SINUMERIK 828D Operating Manual page 621

Parameter
Jaw type
ZC
ZS
ZE
XR
ZR
Mirroring Z
Work offset
Write to the
work offset
ZV
Blank
ZA
ZI
ZB
XA
XI
N
SW or L
W
L
S
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Description
Selecting the jaw type of the counter-spindle. Dimensions of the front edge or stop
edge - (only if spindle chuck data "yes")
Jaw type 1
•
Jaw type 2
•
The counter-spindle chuck dimensions - (only for spindle chuck data "yes")
Stop dimension of the counter-spindle - (only for spindle chuck data "yes")
Jaw dimension of the counter-spindle for jaw type 2 - (only for spindle chuck data
"yes")
Tailstock diameter - (only for spindle chuck data "complete" and tailstock that has
been set up)
Tailstock length - (only for spindle chuck data "complete" and tailstock that has
been set up)
Yes
•
Mirroring is used when machining on the Z axis
No
•
Mirroring is not used when machining on the Z axis
Selecting the work offset
Yes
•
Parameter ZV is displayed
No
•
Parameter ZV is not displayed
Z value of the work offset
The value exceeds the Z value in the selected work offset.
Tube
•
Cylinder
•
Polygon
•
Centered cuboid
•
Initial dimension
Final dimension (abs) or final dimension in relation to ZA (inc)
Machining dimension (abs) or machining dimension in relation to ZA (inc)
Outside diameter – (only for tube and cylinder)
Inside diameter (abs) or wall thickness (inc) – (only for tube)
Number of edges – (only for polygon)
Width across flats or edge length – (only for polygon)
Width of the blank - (only for centered cuboid)
Length of the blank - (only for centered cuboid)
Speed limitation of the counter-spindle
Multi-channel machining
10.2 Multi-channel support
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
rev/min
621