Different Views Of The Workpiece; Side View; Half Section - Siemens SINUMERIK 828D Operating Manual

6.5

Different views of the workpiece

In the graphical display, you can choose between different views so that you constantly have
the best view of the current workpiece machining, or in order to display details or the overall
view of the finished workpiece.
The following views are available:
● Side view
● Half section
● Front view
● 3D view
● 2-window
6.5.1

Side view

Changing the display
You can increase or decrease the size of the simulation graphic and move it, as well as
change the segment.
6.5.2

Half section

Changing the display
You can increase or decrease the size of the simulation graphic and move it, as well as
change the segment.
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
1. Start the simulation.
2. Press the "Side view" softkey.
The side view shows the workpiece in the Z-X plane.
1. Start the simulation.
2. Press the "Other views" and "Half section" softkeys.
The half view shows the workpiece cut in the Z-X plane.
Simulating machining
6.5 Different views of the workpiece
203