Siemens SINUMERIK 828D Operating Manual page 605

Parameter
Fixed
stop
Withdraw blank
F
Cutting-off
cycle
Work offset
Write to the
work offset
ZV - only for work offset
write "yes"
Z4W
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Description
Travel to fixed stop
Yes
•
The counter-spindle stops at a defined distance away from transfer position
Z1 and then traverses with a defined feedrate up to the fixed stop.
No
•
The counter-spindle traverses to the transfer position Z1.
Withdrawing
Withdraw complete blank:
Yes
•
No
•
Feed - withdraw for blank "yes"
Cutting-off cycle in the following block
Yes
•
No
•
Rear face
- for main spindle in counter-spindle
Work offset in which the coordinate system, which was shifted according to ZW
and by ZV as well as mirrored in Z, must be saved:
Basic reference
•
G54
•
G55
•
G56
•
G57
•
...
•
Yes
•
The Z value of the work offset can be directly written to the input screen
form.
No
•
The actual Z value of the work offset is used.
Offset Z = 0 (abs)
•
Workpiece zero is offset in Z direction (inc, the sign is also evaluated)
•
Machining position for special axis (abs.); machine coordinate system
Front face
- for counter-spindle in main spindle
Programming technology functions (cycles)
9.7 Additional cycles and functions in ShopTurn
Unit
mm/min
mm
mm
605