Program header without multi-channel data
If a program is to be executed through one channel, then deselect multi-channel data. You
then have the option of entering cross-program values into the program header as usual.
Parameter
Multi-channel
data
Measurement unit
Data for
Work offset
write to
ZV
Blank
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Description
No
•
This is only possible if you are not using a job list.
The setting of the measurement unit in the program header only refers to the
position data in the actual program.
All other data, such as feedrate or tool offsets, are entered in the unit of meas-
ure that you have set for the entire machine.
Main+counterspindle
•
All values for the main and counterspindle are saved in one data set
Main spindle
•
Data set for the main spindle
Counterspindle
•
Data set for the counterspindle
If the machine does not have a counterspindle, then the entry field "Data for" is
not applicable.
The work offset in which the zero point of the workpiece is saved.
You can also delete the default value of the parameter if you do not want to
specify a work offset.
Yes
•
Parameter ZV is displayed
No
•
Parameter ZV is not displayed
Z value of the work offset
For G54, the Z value is entered into the work offset.
Note:
Please observe the machine manufacturer's data
Define the form and dimensions of the workpiece:
Cylinder
•
XA
Outer diameter ∅
Polygon
•
N
Number of edges
SW / L
Width across flats/edge length
Centered cuboid
•
W
Width of blank
L
Length of blank
Tube
•
XA
Outer diameter ∅
Inner diameter ∅ (abs) or wall thickness (inc)
Multi-channel machining
10.2 Multi-channel support
Unit
mm
inch
mm
mm
mm
mm
mm
631