Siemens SINUMERIK 828D Operating Manual page 455

Input simple
For simple machining operations, you have the option to reduce the wide variety of
parameters to the most important parameters using the "Input" selection field. In this "Input
simple" mode, the hidden parameters are allocated a fixed value that cannot be adjusted.
If the workpiece programming requires it, you can display and change all of the parameters
using "Input complete".
Function
You can mill various rectangular spigots with the "Rectangular spigot" cycle.
You can select from the following shapes with or without a corner radius:
In addition to the required rectangular spigot, you must also define a blank spigot, i.e. the
outer limits of the material. The tool moves at rapid traverse outside this area. The blank
spigot must not overlap adjacent blank spigots and is automatically placed by the cycle in a
central position on the finished spigot.
The spigot is machined using only one infeed. If you want to machine the spigot using
multiple infeeds, you must program the "Rectangular spigot" function several times, with a
continually decreasing finishing allowance.
Clamping the spindle
For ShopTurn, the "Clamp spindle" function can be set up by the machine manufacturer.
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Machine manufacturer
Various defined values can be pre-assigned using setting data.
Please refer to the machine manufacturer's specifications.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Programming technology functions (cycles)
9.4 Milling
455