Siemens SINUMERIK 828D Operating Manual page 599

Procedure
Parameters
L
α
F
Radius compensation
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
1. The ShopTurn program to be processed has been created and you are
in the editor.
2. Press the menu forward key and the "Straight Circle" softkey.
3. Press the "Polar" and "Straight Polar" softkeys.
4. Press the "Rapid traverse" softkey if you want to use rapid traverse
instead of a programmed machining feedrate.
Description
Distance to the pole, end point
Polar angle to the pole, end point (abs) or
Polar angle change to the pole, end point (inc)
The sign specifies the direction.
Machining feedrate
Input defining which side of the contour the cutter travels in the traversing direc-
tion:
Radius compensation to left of contour
Radius compensation to right of contour
Radius compensation off
The set radius compensation remains as previously set
Programming technology functions (cycles)
9.7 Additional cycles and functions in ShopTurn
Unit
mm
Degrees
mm/rev
mm/min
mm/tooth
599