Siemens SINUMERIK 828D Operating Manual page 703

Further parameters
If you have set up unique cutting edge numbers, these are displayed in the first column.
Column heading
D no.
SN
Magazine list icons
Icon/
Marking
Tool type
Red "X"
Yellow triangle pointing
downward
Yellow triangle pointing
upward
Green border
Magazine/location number
Green double arrow
Gray double arrow (con-
figurable)
Red "X"
Procedure
See also
Displaying tool details (Page 707)
Changing the cutting edge position or tool type (Page 717)
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Meaning
Unique cutting edge number
Cutting edge number
1. Select the "Parameter" operating area.
2. Press the "Magazine" softkey.
Meaning
The tool is disabled.
The prewarning limit has been reached.
The tool is in a special state.
Place the cursor on the marked tool. A tooltip provides a
short description.
The tool is preselected.
The magazine location is positioned at the change position.
The magazine location is positioned at the loading position.
The magazine location is disabled.
Tool management
12.8 Magazine
703