Selecting A Program - Siemens SINUMERIK 828D Operating Manual

Machining the workpiece

5.2 Selecting a program

Stopping machining
Canceling machining
5.2 Selecting a program
Procedure
124
Press the <CYCLE STOP> key.
Machining stops immediately. Individual program blocks are not
executed to the end. On the next start, machining is resumed
from the point where it left off.
Press the <RESET> key.
Execution of the program is interrupted. On the next start, machining
will start from the beginning.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
1. Select the "Program manager" operating area.
The directory overview is opened.
2. Select the location where the program is archived (e.g. "NC")
3. Place the cursor on the directory containing the program that you want
to select.
4. Press the <INPUT> key
- OR -
Press the <Cursor right> key.
The directory contents are displayed.
5. Place the cursor on the desired program.
6. Press the "Select" softkey.
The program is selected.
When the program has been successfully selected, an automatic
changeover to the "Machine" operating area occurs.
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Turning