Siemens SINUMERIK 828D Operating Manual page 319

Parameter Description
ZD - (only for Depth for feedrate reduction (abs) or depth for feedrate reduction in relation to Z1
through drilling (inc).
"yes")
FD - (only for Feedrate for through drilling referred to drilling feedrate F.
through drilling
Feedrate for through drilling (ShopTurn).
"yes")
Feedrate for through drilling (G code).
DT - (only for
Dwell time at final depth in seconds
•
through drilling
Dwell time at final depth in revolutions
•
"no")
Retraction
Retraction to pilot hole depth
•
Retraction to retraction plane
•
FR Retraction in rapid traverse
Direction of
•
spindle rotation
Retraction with stationary spindle
during retrac-
tion
•
•
SR / VR
Spindle speed for retraction referred to the drilling speed
•
(only for select-
Spindle speed for retraction
•
ed spindle
Constant cutting rate VR for retraction
•
direction of
rotation)
Coolant off - M function to switch off the coolant
(only G code)
Parameters in the "Input simple" mode
G code program parameters
Input
RP Retraction plane
F Feedrate
S / V Spindle speed or con-
stant cutting rate
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
simple
•
mm
mm/min
mm/rev
rpm
m/min
Programming technology functions (cycles)
ShopTurn program parameters
T Tool name
D Cutting edge number
F Feedrate
S / V Spindle speed or constant
cutting rate
9.1 Drilling
Unit
mm
%
mm/min or mm/rev.
distance/min or
distance/rev
s
U
%
rpm
m/min
mm/min
mm/rev
rpm
m/min
319