Siemens SINUMERIK 828D Operating Manual page 411

Parameter Description
XD - (only for ∇ machining)
- (only for blank description, cylinder and allowance)
•
•
ZD - (only for ∇ machining)
- (only for blank description, cylinder and allowance)
•
•
Allowance Allowance for pre-finishing - (only for ∇∇∇)
•
•
U1 Compensation allowance in X and Z direction (inc) – (only for allowance)
•
•
Relief cuts Machine relief cuts (cannot be changed)
FR Insertion feedrate, relief cuts
* Unit of feedrate as programmed before the cycle call
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
For blank description, cylinder
– Version, absolute:
Cylinder dimension ∅ (abs)
– Version incremental:
Allowance (inc) to maximum values of the CYCLE62 finished part contour
For blank description, allowance
– Allowance on the CYCLE62 finished part contour (inc)
For blank description, cylinder
– Version, absolute:
Cylinder dimension (abs)
– Version incremental:
Allowance (inc) to maximum values of the CYCLE62 finished part contour
For blank description, allowance
– Allowance on the CYCLE62 finished part contour (inc)
Yes
U1 contour allowance
No
Positive value: Compensation allowance is kept
Negative value: Compensation allowance is removed in addition to finishing
allowance
Programming technology functions (cycles)
9.3 Contour turning
Unit
mm
mm
mm
411