Siemens SINUMERIK 828D Operating Manual page 633

Parameter
ZT
S
Spindle chuck data
Spindle chuck data
Data for
Retraction
XRA
XRI
ZRA
ZRI
Tailstock
XRR
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Description
Tool change point Z
Spindle speed
Yes
•
You enter spindle chuck data in the program.
No
•
Spindle chuck data are transferred from the setting data.
Note:
Please observe the machine manufacturer's instructions.
Only chuck
•
You enter spindle chuck data in the program.
Complete
•
You enter tailstock data in the program.
Note:
Please observe the machine manufacturer's instructions.
If several spindles have been set up, the program can operate at both spindles.
Select the 2nd spindle
Main spindle
•
Counterspindle
•
Empty
•
The program only operates at one spindle
The retraction area indicates the area outside of which collision-free traversing
of the axes must be possible.
simple
•
extended – not for a "pipe" blank
•
all
•
Retraction plane X external ∅ (abs) or
retraction plane X referred to XA (inc)
- for "basic" retraction, only for a "pipe" blank
retraction plane X internal ∅ (abs) or
retraction plane X referred to XI (inc)
Retraction plane Z front (abs) or
retraction plane Z referred to ZA (inc)
Retraction plane Z rear – only for retraction "all"
Yes
•
No
•
Retraction plane tailstock – only "Yes" for tailstock
Multi-channel machining
10.2 Multi-channel support
Unit
mm
rev/min
mm
mm
mm
mm
mm
633