Copying/Pasting/Deleting A Program Block - Siemens SINUMERIK 828D Operating Manual

Machining the workpiece
5.10 Editing a program
5.10.3

Copying/pasting/deleting a program block

Precondition
The program is opened in the editor.
Procedure
Numbering the program blocks
148
1. Press the "Mark" softkey.
- OR -
Press the <SELECT> key.
2. Select the desired program blocks with the cursor or mouse.
3. Press the "Copy" softkey in order to copy the selection to the buffer
memory.
4. Place the cursor on the desired insertion point in the program and press
the "Paste" softkey.
The content of the buffer memory is pasted.
- OR -
Press the "Cut" softkey to delete the selected program blocks and to
copy them into the buffer memory.
Note: When editing a program, you cannot copy or cut more than 1024
lines. While a program that is not on the NC is opened (progress display
less than 100%), you cannot copy or cut more than 10 lines or insert
more than 1024 characters.
If you have selected the "Automatic numbering" option for the editor,
then the newly added program blocks are allocated a block number (N
number).
The following rules apply:
• When creating a new program, the first line is allocated the "first
block number".
• If, up until now, the program had no N number, then the program
block inserted is allocated the starting block number defined in the
"First block number" input field.
• If N numbers already exist before and after the insertion point of a
new program block, then the N number before the insertion point is
incremented by 1.
• If there are no N numbers before or after the insertion point, then the
maximum N number in the program is increased by the "increment"
defined in the settings.
Note:
After exiting the program, you have the option of renumbering the pro-
gram blocks.
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Turning