Siemens SINUMERIK 828D Operating Manual page 531

Parameter
Approach strategy
R1
L1
FZ
(only for G code)
FZ
(only for ShopTurn)
Retraction
Retraction strategy
R2
L2
Lift mode
FS
ZFS
* Unit of feedrate as programmed before the cycle call
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Description
axis-by-axis - (only for "quadrant, semi-circle or straight line" approach)
•
spatial - (only for "quadrant, semi-circle or straight line" approach)
•
Approach radius - (only for "quadrant or semi-circle" approach)
Approach distance - (only for "straight line" approach)
Depth infeed rate
Depth infeed rate
Planar retraction mode:
Quadrant:
•
Part of a spiral (only with path milling left and right of the contour)
Semi-circle:
•
Part of a spiral (only with path milling left and right of the contour)
Straight line:
•
axis-by-axis
•
spatial
•
Retraction radius - (only for "quadrant or semi-circle" retraction)
Retraction distance - (only for "straight line" retraction)
If more than one depth infeed is necessary, specify the retraction height to
which the tool retracts between the individual infeeds (at the transition from the
end of the contour to the start).
Lift mode before new infeed
No retraction
•
to RP
•
Z0 + safety clearance
•
By the safety clearance
•
Chamfer width for chamfering - (only for chamfering machining)
Insertion depth of tool tip (abs or inc) - (for chamfering machining only)
Programming technology functions (cycles)
9.5 Contour milling
Unit
mm
mm
*
mm/min
mm/tooth
mm
mm
mm
mm
531