Siemens SINUMERIK 828D Operating Manual page 500

Programming technology functions (cycles)
9.4 Milling
Parameter
C0
Y0
Z0
X0
(only for ShopTurn)
W
L
Z1
(only for G code)
Z1 or X1
(only for G code)
DXY
DZ
UXY
UZ
FS
ZFS
* Unit of feedrate as programmed before the cycle call
Hidden parameters
The following parameters are hidden. They are pre-assigned fixed values or values that can
be adjusted using setting data.
Parameter
PL (only for G code)
SC (only for G code)
Reference point
Machining
position
α0
500
Description
Peripheral surface Y: The positions refer to the reference point:
Positioning angle for machining surface
Reference point Y
Reference point Z
Reference point X
Slot width
Slot length
Slot depth (abs) or depth relative to Z0 (abs) – (only for ∇, ∇∇, ∇∇∇ and ∇∇∇
base)
Slot depth (abs) or depth relative to Z0 or X0 (abs) – (only for ∇, ∇∇, ∇∇∇, ∇∇∇
base)
(Z1 for machining surface, face C/Y or X1 for peripheral surface C/Y)
Maximum plane infeed
•
Maximum plane infeed as a percentage of the milling cutter diameter-
•
(only for ∇)
Maximum depth infeed – (only for ∇, ∇∇, ∇∇∇ and ∇∇∇ edge) - (only for vortex
milling)
Plane finishing allowance (slot edge) - (only for ∇, ∇∇ and ∇∇∇ base)
Depth finishing allowance (slot base) - (only for ∇, ∇∇ and ∇∇∇ edge)
Chamfer width for chamfering (inc) - (for chamfering only)
Insertion depth of tool tip (abs or inc) - (for chamfering only)
Description
Machining plane
Safety clearance
Position of the reference point: Center
Mill slot at the programmed position (X0, Y0, Z0).
Angle of rotation of slot
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Value Can be set in SD
Defined in MD
52005
1 mm
Single posi-
tion
0°
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Degrees
mm
mm
mm
mm
mm
mm
mm
mm
%
mm
mm
mm
mm
mm
x
Turning