Siemens SINUMERIK 828D Operating Manual page 642

Multi-channel machining
10.2 Multi-channel support
Procedure
See also
Optimizing the machining time (Page 644)
642
1. Select the required job list.
2. Press the "Open" softkey.
The job list is opened in the editor.
3. Press the ">>" and "View" softkeys.
4. Press the softkey "Synchron. view".
5. Press the "Synchronizing" softkey if you wish to update the view
after changes.
6. Press the "Open all blocks" softkey if you wish to view all of the
program blocks in the synchronized display.
7. Press the "Close all blocks" softkey, if you wish to close the
blocks to achieve a higher degree of transparency.
8. Select the required program.
9. Press the "Full screen" softkey.
The two-channel display is changed into a single-channel display
and the selected program is displayed using the complete editor
window.
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Turning