Siemens SINUMERIK 828D Operating Manual page 35

Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
<Minus>
• Closes a directory which contains the element.
• Reduces the size of the graphic view for simulation and
<Equals>
Opens the calculator in the entry fields.
<Asterisk>
Opens a directory with all of the subdirectories.
<Tilde>
Changes the sign of a number between plus and minus.
<INSERT>
• Opens an editing window in the insert mode. Pressing the
• Opens a selection box and shows the selection possibilities.
• In the machining step program, enters an empty line for G
• Changes into the double editor or into the multi-channel view
+ <INSERT> + <SHIFT>
For G code programming, for a cycle call activates or deac-
tivates the edit mode.
<INPUT>
• Completes input of a value in the entry field.
• Opens a directory or a program.
• Inserts an empty program block if the cursor is positioned at
• Inserts a character to select a new line and the program
• In the G code, inserts a new line after the program block.
• In the machining step program, inserts a new line for G code
• Changes into the double editor or into the multi-channel view
<ALARM> - only OP 010 and OP 010C
Calls the "Diagnosis" operating area.
traces.
key again, exits the window and the entries are undone.
code.
from the edit mode into the operating mode. You can return
to the edit mode by pressing the key again.
the end of a program block.
block is split up into two parts.
e
from the edit mode into the operating mode. You can return
to the edit mode by pressing the key again.
Introduction
2.2 Operator panel fronts
35