Siemens SINUMERIK 828D Operating Manual page 458

Programming technology functions (cycles)
9.4 Milling
Parameter
Machining position
X0
Y0
Z0
(only for G code)
X0 or L0
Y0 or C0
Z0
(only for ShopTurn)
CP
X0 or L0
Y0 or C0
Z0
(only for ShopTurn)
Y0 or C0
Z0
X0
(only for ShopTurn)
C0
Y0
Z0
X0
(only for ShopTurn)
W
L
R
α0
Z1
DZ
UXY
458
Description
Single position
•
Mill rectangular pocket at the programmed position (X0, Y0, Z0).
Position pattern
•
Position with MCALL
The positions refer to the reference point:
Reference point X – (only for single position)
Reference point Y – (only for single position)
Reference point Z
Face C: The positions refer to the reference point:
Reference point X or reference point length polar – (only for single position)
Reference point Y or reference point angle polar – (only for single position)
Reference point Z – (only for single position)
Face Y: The positions refer to the reference point:
Positioning angle for machining area – (only single position)
Reference point X or reference point length polar – (only for single position)
Reference point Y or reference point angle polar – (only for single position)
Reference point Z – (only for single position)
Peripheral surface C: The positions refer to the reference point:
Reference point Y or reference point angle polar – (only for single position)
Reference point Z – (only for single position)
Cylinder diameter ∅ – (only for single position)
Peripheral surface Y: The positions refer to the reference point:
Positioning angle for machining surface – (only for single position)
Reference point Y – (only for single position)
Reference point Z – (only for single position)
Reference point X – (only for single position)
Width of spigot
Length of spigot
Corner radius
Angle of rotation
Spigot depth (abs) or depth relative to Z0 or X0 (inc) - (only for ∇ and ∇∇∇)
Maximum depth infeed - (only for ∇ and ∇∇∇)
Plane finishing allowance for the length (L) and width (W) of the rectangular spigot.
Smaller rectangular spigot dimensions are obtained by calling the cycle again and
programming it with a lower finishing allowance. - (only for ∇ and ∇∇∇)
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Unit
mm
mm
mm
mm
mm
mm
Degrees
mm
mm or de-
grees
mm
mm or de-
grees
mm
mm
Degrees
mm
mm
mm
mm
mm
mm
Degrees
mm
mm
mm
Turning