Stock Removal Rest (Cycle952) - Siemens SINUMERIK 828D Operating Manual

Programming technology functions (cycles)
9.3 Contour turning
Hidden parameters
Parameter Description
PL (only for G Machining plane
code)
Residual material With subsequent residual material removal
SC (only for G Safety clearance
code)
Selection Always round on the contour
Uniform cut segmentation
Constant cutting depth
DI Continuous cut - (only for ∇)
Set machining area Set machining area limits
limits
Relief cuts Machine relief cuts (grayed out)
9.3.9

Stock removal rest (CYCLE952)

Function
Using the "Stock removal residual" function, you remove material that has remained for stock
removal along the contour.
During stock removal along the contour, the cycle automatically detects any residual material
and generates an updated blank contour. for ShopTurn, the updated unmachined-part
contour is automatically generated. For a C code program, for stock removal residual
material, "Yes" must be programmed. Material that remains as part of the finishing allowance
is not residual material. Using the "Stock removal residual material" function, you can
remove unwanted material with a suitable tool.
412
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Software option
For stock removal of residual material, you require the option "residual materi-
al detection and machining".
Value Can be set in SD
Defined in MD
52005
No
0
No
Yes
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
x
Turning