Machining the workpiece
5.10 Editing a program
5.10.5
Creating a program block
In order to structure programs to achieve a higher degree of transparency, you have the
option of combining several blocks (G-code and/or ShopTurn machining steps) to form
program blocks.
Program blocks can be created in two stages. This means that you can form additional
blocks within a block (nesting).
You then have the option of opening and closing these blocks depending on your
requirement.
Display
Text
Spindle
Addit. run-in code
Automat. retraction
Structuring programs
● Before generating the actual program, generate a program frame using empty blocks.
● By forming blocks, structure existing G code or ShopTurn programs.
150
Meaning
Block designation
Selecting the spindle
•
Defines at which spindle a program block is to be executed.
Yes
•
If the block is not to be executed, because the specified spindle is not to
be used, it is possible to temporarily activate a so-called "Addit. run-in
code".
No
•
Yes
•
Block start and block end are moved to the tool change point, i.e. the tool
is brought into a safe range.
No
•
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Turning