Siemens SINUMERIK 828D Operating Manual page 554

Programming technology functions (cycles)
9.5 Contour milling
parameters
Z1
CP
C0
DXY
DZ
Lift mode
FS
ZFS
554
Description
Pocket depth (abs) or depth referred to Z0
Positioning angle for machining area
- (only for ShopTurn, machining surface, face Y)
Positioning angle for machining surface
- (only for ShopTurn, machining surface, peripheral surface Y)
Maximum plane infeed
•
Maximum plane infeed as a percentage of the milling cutter diameter
•
Maximum depth infeed
Lift mode before new infeed
If the machining operation requires several points of insertion, the retraction
height can be programmed:
To retraction plane
•
Z0 + safety clearance
•
When making the transition to the next insertion point, the tool returns to this
height. If there are no elements larger than Z0 in the pocket area, Z0 + safety
clearance" can be selected as the lift mode.
Chamfer width for chamfering - (only for chamfering machining)
Insertion depth of tool tip (abs or inc) - (for chamfering machining only)
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Unit
mm
Degrees
Degrees
mm
%
mm
mm
mm
mm
Turning