Siemens SINUMERIK 828D Operating Manual page 472

Programming technology functions (cycles)
9.4 Milling
Parameter Description
R1 and FS1 Rounding radius or chamfer width
Z1 Multi-edge depth (abs) or depth in relation to Z0 (inc) - (only for ∇, ∇∇∇ and ∇∇∇ edge)
DXY
•
•
DZ Maximum depth infeed – (only for ∇ and ∇∇∇)
UXY Plane finishing allowance - (only for ∇, ∇∇∇ and ∇∇∇ edge).
UZ Depth finishing allowance (only for ∇ and ∇∇∇)
FS Chamfer width for chamfering - (for chamfering only)
ZFS Insertion depth of tool tip (abs or inc) - (for chamfering only)
* Unit of feedrate as programmed before the cycle call
Hidden parameters
The following parameters are hidden. They are pre-assigned fixed values or values that can
be adjusted using setting data.
Parameter Description
PL (only for G Machining plane
code)
SC (only for G Safety clearance
code)
Machining Mill multi-edge at the programmed position (X0, Y0, Z0).
position (only for G
code)
α0 Angle of rotation
472
Maximum plane infeed
Maximum plane infeed as a percentage of the milling cutter diameter
- (only for ∇ and ∇∇∇)
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Value Can be set in SD
Defined in MD
52005
1 mm
Single posi-
tion
0°
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
mm
mm
%
mm
mm
mm
mm
mm
x
Turning