Siemens SINUMERIK 828D Operating Manual page 551

Parameter
UZ
FS
ZFS
* Unit of feedrate as programmed before the cycle call
Hidden parameters
The following parameters are hidden. They are pre-assigned fixed values or values that can
be adjusted using setting data.
Parameter Description
PL (only for G Machining plane
code)
SC (only for G Safety clearance
code)
Lift mode Lift mode before new infeed - (only for ∇, ∇∇∇ base or ∇∇∇
edge)
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Description
Depth finishing allowance (only for ∇ and ∇∇∇ base)
Chamfer width for chamfering - (for chamfering only)
Insertion depth of tool tip (abs or inc) - (for chamfering only)
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Programming technology functions (cycles)
Value Can be set in SD
Defined in MD
52005
1 mm
to RP
9.5 Contour milling
mm
mm
mm
x
551