Siemens SINUMERIK 828D Operating Manual page 308

Programming technology functions (cycles)
9.1 Drilling
Parameters in the "Input complete" mode
G code program parameters
Input
PL Machining plane
RP Retraction plane
SC Safety clearance
Parameter Description
Machining posi-
Single position
•
tion
(only for G
Drill hole at programmed position
code)
Position pattern
•
Position with MCALL
Z0 (only for G Reference point Z
code)
Machining
Face C
•
surface
Face Y
•
Peripheral surface C
•
(only for Shop-
Turn) Peripheral surface Y
•
Position
At the front (face)
•
(only for Shop-
At the rear (face)
•
Turn)
Outside (peripheral surface)
•
Inside (peripheral surface)
•
Clamp/release spindle
The function must be set up by the machine manufacturer.
(only for Shop-
Turn)
Machining
Swarf removal
•
The drill is retracted from the workpiece for swarf removal.
Chip breaking
•
The drill is retracted by the retraction distance V2 for chip breaking.
308
ShopTurn program parameters
Complete
•
T
mm D
mm F
S / V
Tool name
Cutting edge number
Feedrate
Spindle speed or constant cut-
ting rate
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
mm/min
mm/rev
rpm
m/min
Unit
mm
Turning