Siemens SINUMERIK 828D Operating Manual page 325

Parameters in the "Input complete" mode
G code program parameters
Input (only for G code)
PL Machining plane
RP Retraction plane
SC Safety clearance
Parameter Description
Compensating
with compensating chuck
•
chuck mode
without compensating chuck
•
Machining posi-
Single position
•
tion (only for G
Drill hole at programmed position
code)
Position pattern
•
Position with MCALL
Z0 (only for G Reference point Z
code)
Machining - (with You can select the following technologies for tapping:
compensating
with encoder
•
chuck)
Tapping with spindle encoder
without encoder
•
Tapping without spindle encoder - the following fields are displayed:
–
–
Note:
For ShopMill, the selection box is only displayed if tapping without encoder is enabled.
Please observe the information provided by your machine manufacturer.
SR (only for Spindle speed for retraction - (only for spindle speed "S")
ShopTurn)
VR (only for Constant cutting rate for retraction - (only for constant cutting rate "V")
ShopTurn)
Machining
Face C
•
surface
Face Y
•
(only for Shop-
Face B
•
Turn)
Peripheral surface C
•
Peripheral surface Y
•
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Complete
•
mm
mm
Select the "pitch" parameter (only G code)
Enter parameter "DT" (only ShopMill)
Programming technology functions (cycles)
ShopTurn program parameters
T Tool name
D Cutting edge number
S / V Spindle speed or constant cut-
ting rate
9.1 Drilling
rpm
m/min
Unit
mm
rev/min
m/min
325