Siemens SINUMERIK 828D Operating Manual page 466

Programming technology functions (cycles)
9.4 Milling
Parameter Description
FZ (only for G Depth infeed rate
code)
Machining
•
surface (only for
•
ShopTurn)
•
•
Position (only for
•
ShopTurn)
•
•
•
Clamp/release spindle (only for end face Y/peripheral surface Y)
The function must be set up by the machine manufacturer.
(only for ShopTurn)
Machining The following machining operations can be selected:
•
•
•
The positions refer to the reference point:
X0 Reference point X
Y0 Reference point Y
Z0 Reference point Z
(only for G code)
Face C: The positions refer to the reference point:
X0 or L0 Reference point X or reference point length polar
Y0 or C0 Reference point Y or reference point angle polar
Z0 (only for Shop- Reference point Z
Turn)
Face Y: The positions refer to the reference point:
CP Positioning angle for machining area
X0 or L0 Reference point X or reference point length polar
Y0 or C0 Reference point Y or reference point angle polar
Z0 (only for Shop- Reference point Z
Turn)
466
Face C
Face Y
Peripheral surface C
Peripheral surface Y
At the front (face)
At the rear (face)
Outside (peripheral surface)
Inside (peripheral surface)
∇ (roughing)
∇∇∇ (finishing)
Chamfering
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
*
mm
mm
mm
mm
mm or
degrees
mm
Degrees
mm
mm or
degrees
mm
Turning