Siemens SINUMERIK 828D Operating Manual page 224

Creating a G code program
7.6 Blank input
ZC3 Chuck dimension of the counterspindle - (only for spindle chuck data "yes" and for a
counterspindle that has been set up)
ZS3 Stop dimension of the counterspindle - (only for spindle chuck data "yes" and for a coun-
terspindle that has been set up)
ZE3 Jaw dimension of the counterspindle with jaw type 2 - (only for spindle chuck data "yes"
and for a counterspindle that has been set up)
XR3 Tailstock diameter - (only for spindle chuck data "complete" and tailstock that has been
set up)
ZR3 Tailstock length - (only for spindle chuck data "complete" and tailstock that has been set
up)
XA Outside diameter – (only for tube and cylinder)
XI Inside diameter (abs) or wall thickness (inc) – (only for tube)
N Number of edges – (only for polygon)
SW or L Width across flats or edge length – (only for polygon)
W Width of the blank - (only for centered cuboid)
L Length of the blank - (only for centered cuboid)
224
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
Turning