Contour Turning With Manual Machine - Siemens SINUMERIK 828D Operating Manual

Working with Manual Machine
15.6 More complex machining
15.6.3

Contour turning with Manual machine

For contour turning of simple geometric shapes, the same range of technological functions
(cycles) as in automatic mode is available.
Parameters
The parameters of the input screen forms correspond to the parameters under Automatic
(see Section Contour turning (Page 390)).
Last contour
818
Machine manufacturer
Please refer to the machine manufacturer's specifications.
⇒
If you have created a contour since the startup of the machine, the "Last con-
tour" softkey is available. You then have the option to reopen the input screen
with the last contour you entered in "Manual machine" for editing.
⇒
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Turning