Plunge-Cutting Rest (Cycle952) - Siemens SINUMERIK 828D Operating Manual

Programming technology functions (cycles)
9.3 Contour turning
Parameter Description
Allowance Allowance for pre-finishing - (only for ∇∇∇)
•
•
U1 Compensation allowance in X and Z direction (inc) – (only for allowance)
•
•
* Unit of feedrate as programmed before the cycle call
Hidden parameters
Parameter Description
Residual material With subsequent residual material removal
SC Safety clearance
DI Continuous cut - (only for ∇)
Set machining area Set machining area limits
limits
N Number of grooves
9.3.11

Plunge-cutting rest (CYCLE952)

Function
The "Grooving residual material" function is used when you want to machine the material
that remained after grooving along the contour.
During grooving ShopTurn, the cycle automatically detects any residual material and
generates an updated blank contour. For a G code program, the function must have been
previously selected. Material that remains as part of the finishing allowance is not residual
material. The "Grooving residual material" function allows you to remove unwanted material
with a suitable tool.
420
Yes
U1 contour allowance
No
Positive value: Compensation allowance is kept
Negative value: Compensation allowance is removed in addition to finishing
allowance
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Software option
To machine residual material, you require the "Residual material detection
and machining" option.
Value Can be set in SD
No
0
No
1
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Unit
mm
x
Turning