Siemens SINUMERIK 828D Operating Manual page 439

Parameter Description
Machining The following machining operations can be selected:
∇ (roughing)
•
∇∇∇ (finishing)
•
∇∇∇ edge (edge finishing)
•
Chamfering
•
Machining
Single position
•
position
Mill rectangular pocket at the programmed position (X0, Y0, Z0).
Position pattern
•
Position with MCALL
The positions refer to the reference point:
X0 Reference point X – (only for single position)
Y0 Reference point Y – (only for single position)
Z0 Reference point Z
(only for G code)
Face C: The positions refer to the reference point:
X0 or L0 Reference point X or reference point length polar – (only for single position)
Y0 or C0 Reference point Y or reference point angle polar - (only for single position)
Z0 Reference point Z - (only for single position)
(only for Shop-
Turn)
Face Y: The positions refer to the reference point:
CP Positioning angle for machining area – (only single position)
X0 or L0 Reference point X or reference point length polar – (only for single position)
Y0 or C0 Reference point Y or reference point angle polar - (only for single position)
Z0 Reference point Z - (only for single position)
(only for Shop-
Turn)
Peripheral surface C: The positions refer to the reference point:
Y0 or C0 Reference point Y or reference point angle polar - (only for single position)
Reference point Z - (only for single position)
Z0
Cylinder diameter ∅ – (only for single position)
X0
(only for Shop-
Turn)
Peripheral surface Y: The positions refer to the reference point:
C0 Positioning angle for machining surface – (only for single position)
Y0 Reference point Y – (only for single position)
Z0 Reference point Z – (only for single position)
X0 Reference point X – (only for single position)
(only for Shop-
Turn)
W Pocket width
L Pocket length
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Programming technology functions (cycles)
9.4 Milling
Unit
mm
mm
mm
mm
mm or de-
grees
mm
Degrees
mm
mm or de-
grees
mm
mm or de-
grees
mm
mm
Degrees
mm
mm
mm
mm
mm
439