Siemens SINUMERIK 828D Operating Manual page 513

Parameter
X0 or L0
Y0 or C0
Z0
(only ShopTurn)
CP
X0 or L0
Y0 or C0
Z0
(only ShopTurn)
Y0 or C0
Z0
X0
(only ShopTurn)
C0
Y0
Z0
X0
(only ShopTurn)
Z1
W
DX1 or α2
DX1 or DX2
α1
XM or LM
(only G code)
YM or αM
(only G code)
YM or CM
(only ShopTurn)
ZM
(only ShopTurn)
* Unit of feedrate as programmed before the cycle call
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Description
Face C: The positions refer to the reference point:
Reference point X or reference point length polar
Reference point Y or reference point angle polar
Reference point Z
Face Y: The positions refer to the reference point:
Positioning angle for machining area
Reference point X or reference point length polar
Reference point Y or reference point angle polar
Reference point Z
Peripheral surface C: The positions refer to the reference point:
Reference point Y or reference point angle polar – (only for single position)
Reference point Z
Cylinder diameter ∅
Peripheral surface Y: The positions refer to the reference point:
Positioning angle for machining surface – (only for single position)
Reference point Y
Reference point Z
Reference point X
Engraving depth (abs) or referenced depth (inc)
Character height
Distance between characters or angle of opening – (for curved alignment
only)
Distance between characters or total width – (for linear alignment only)
Text direction (for linear alignment only)
Center point X (abs) or center point length polar
– (for curved alignment only)
Center point Y (abs) or center point angle polar
– (for curved alignment only)
Center point Y or C (abs.) – (for curved alignment only)
- (only for machining surface, peripheral surface C/Y)
Center point Z (abs.) – (for curved alignment only)
- (only for machining surface, peripheral surface C/Y)
Programming technology functions (cycles)
9.4 Milling
Unit
mm
mm or de-
grees
mm
Degrees
mm
mm or de-
grees
mm
mm or de-
grees
mm
mm
Degrees
mm
mm
mm
mm
mm
mm or
Degrees
mm
Degrees
mm
mm
mm or de-
grees
mm
513