Siemens SINUMERIK 828D Operating Manual page 119

Procedure
Table 4- 1
Parameter
T
D
F
S / V
Spindle M function
Machining
Position
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
1. Press the "Machine" operating area key
2. Press the <JOG> key.
3. Press the "Stock removal" softkey.
4. Enter desired values for the parameters.
5. Press the "OK" softkey.
The parameter screen is closed.
6. Press the <CYCLE START> key.
The "Stock removal" cycle is started.
You can return to the parameter screen form at any time to check and
correct the inputs.
Description
Tool name
Cutting edge number
Feedrate
Spindle speed or constant cutting rate
Direction of spindle rotation (only when ShopTurn is not active)
•
•
∇ (roughing)
•
∇∇∇ (finishing)
•
Machining position
Working in manual mode
4.6 Simple stock removal of workpiece
Unit
mm/rev
rpm
m/min
119