Siemens SINUMERIK 828D Operating Manual page 441

Parameter Description
ER Radius of helix – (for helical insertion only)
The radius cannot be any larger than the milling cutter radius; otherwise, material will
remain.
EW Maximum insertion angle – (for insertion with oscillation only)
Solid machining
Complete machining
•
(for roughing only)
The rectangular pocket is milled from the solid material.
Post machining
•
The size of any existing smaller rectangular pocket or hole is increased in one or
more axes. You must program parameters AZ, W1 and L1 for this purpose.
AZ Depth of premachining – (for post machining only)
W1 Width of premachining – (for post machining only)
L1 Length of premachining – (for post machining only)
FS Chamfer width for chamfering - (for chamfering only)
ZFS Insertion depth of tool tip (abs or inc) – (for chamfering only)
* Unit of feedrate as programmed before the cycle call
Parameters in the "Input simple" mode
G code program parameters
Input
Milling direction
RP Retraction plane
F Feedrate
Parameter Description
Machining The following machining operations can be selected:
•
•
•
•
Machining
•
surface (only for
•
ShopTurn)
•
•
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
simple
•
mm
*
∇ (roughing)
∇∇∇ (finishing)
∇∇∇ edge (edge finishing)
Chamfering
Face C
Face Y
Peripheral surface C
Peripheral surface Y
Programming technology functions (cycles)
ShopTurn program parmeters
T Tool name
D Cutting edge number
F Feedrate
S / V Spindle speed or constant
cutting rate
9.4 Milling
Unit
mm
Degrees
mm
mm
mm
mm
mm
mm/min
mm/rev
rpm
m/min
441