Table of Contents
Advertisement
B.1Configuring the Direct Connection Using GeminiConnect Tool
This section describes how configure the Direct IP connection using the
G eminiConnect software package .
1. Unzip the GeminiConnect package, available from the Siemens web site.
2. Double click on the GeminiConnect.exe file
3. Follow the on-screen instructions.
If the GeminiConnect software is not available, the configuration can be performed
as described in the following sections. However, use of GeminiConnect is strongly
advised, to make the installation as simple and automatic as possible.
B.2 Installing the PC Direct Connection Driver
This section describes how to manually configure the PC serial port to be a "Direct
Communications Cable".
1. If the serial port is a non-standard one (Bluetooth/USB), make sure the Serial
port is connected and working.
2. Open Phone and Modem Options from the Control-Panel
3. Click on the Modems tab at the top of the window.
4. Click Add
5. Select the Don't detect my modem option, click Next
6. From the left hand pane, select (Standard Modem Types)
7. From the right hand pane, select Communications cable between two
computers
8. Click Next
9. Select All Ports, click Next
10. Click Finish
Once the driver is installed, the communications settings can be configured as
described in the following section.
B.3 Configuring the Direct Connection Settings Manually
This section describes how configure the Direct IP connection using the standard
Windows DUN (Dial-Up Networking) system. The steps only need to be performed
once.
1. Make sure the Handset Serial Cable is DISCONNECTED
2. Open the Network Connections Window from the Control-Panel
3. Click New Connection Wizard, Click Next
4. Select Set up an advanced connection, Click Next
5. Select Connect directly to another computer", Click *Next
6. Select Guest, Click Next
667/HB/31601/000
Page 117
UTMC OTU/MOVA Handbook
Issue 5
Hide quick links:
Advertisement
Table of Contents
