Siemens SINUMERIK 828D Operating Manual page 540

Programming technology functions (cycles)
9.5 Contour milling
Parameters in the "Input complete" mode
Parameters, G code program
Input
PRG Name of the program to be generated
PL Machining plane
Milling direction
Climbing
•
Conventional
•
milling
RP Retraction plane
SC Safety clearance
F Feedrate
Parameter
Machining
surface
(only for ShopTurn)
(only for ShopTurn)
Machining
Z0
Z1
CP
C0
DXY
DZ
UXY
UZ
540
Complete
•
mm
mm
mm/min
Description
Face C
•
Face Y
•
Face B
•
Peripheral surface C
•
Peripheral surface Y
•
Clamp/release spindle (only for end face Y/B and peripheral surface Y)
The function must be set up by the machine manufacturer.
The following machining operations can be selected:
∇ (roughing)
•
∇∇∇ base (base finishing)
•
∇∇∇ edge (edge finishing)
•
Chamfering
•
Reference point in the tool axis Z
Pocket depth (abs) or depth referred to Z0
Positioning angle for machining area
- (only for ShopTurn, machining surface, face Y)
Positioning angle for machining surface
- (only for ShopTurn, machining surface, peripheral surface Y)
Maximum plane infeed
•
Maximum plane infeed as a percentage of the milling cutter diameter
•
Maximum depth infeed
Finishing allowance, plane
Finishing allowance, depth
Parameters, ShopTurn program
T Tool name
D Cutting edge number
F Feedrate
S / V Spindle speed or constant cut-
ting rate
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
mm/min
mm/tooth
rpm
m/min
Unit
mm
mm
Degrees
Degrees
mm
%
mm
mm
mm
Turning