Siemens SINUMERIK 828D Operating Manual page 326

Programming technology functions (cycles)
9.1 Drilling
Parameter Description
Position
At the front (face)
•
(only for Shop-
At the rear (face)
•
Turn)
Outside (peripheral surface)
•
Inside (peripheral surface)
•
Clamp/release spindle
The function must be set up by the machine manufacturer.
(only for Shop-
Turn)
Z1 End point of the thread (abs) or thread length (inc) - only for G code and ShopTurn
machining surface "face")
It is inserted into the workpiece until it reaches Z1.
X1 End point of the thread (abs) or thread length (inc) - (only for ShopTurn machining
surface, "peripheral")
It is inserted into the workpiece until X1 is reached.
Pitch - (only ma-
User input
•
chining without
Pitch is obtained from the input
encoder)
Active feedrate
•
(only for G code)
Pitch is obtained from the feedrate
Thread Direction of rotation of the thread
(only for G code)
Right-hand thread
•
Left-hand thread
•
(only in mode "without compensating chuck")
Table Thread table selection:
without
•
ISO metric
•
Whitworth BSW
•
Whitworth BSP
•
UNC
•
Selection Selection of table value: e.g.
M3; M10; etc. (ISO metric)
•
W3/4"; etc. (Whitworth BSW)
•
G3/4"; etc. (Whitworth BSP)
•
1" - 8 UNC; etc. (UNC)
•
326
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Unit
mm
mm
Turning