Siemens SINUMERIK 828D Operating Manual page 460

Programming technology functions (cycles)
9.4 Milling
Parameter
X0
Y0
Z0
(only for G code)
X0 or L0
Y0 or C0
Z0 (only for ShopTurn)
CP
X0 or L0
Y0 or C0
Z0 (only for ShopTurn)
C0
Y0
Z0
X0
(only for ShopTurn)
W
L
R
Z1
DZ
UXY
UZ
W1
L1
FS
ZFS
* Unit of feedrate as programmed before the cycle call
460
Description
The positions refer to the reference point:
Reference point X
Reference point Y
Reference point Z
Face C: The positions refer to the reference point:
Reference point X or reference point length polar
Reference point Y or reference point angle polar
Reference point Z
Face Y: The positions refer to the reference point:
Positioning angle for machining area
Reference point X or reference point length polar
Reference point Y or reference point angle polar
Reference point Z
Peripheral surface Y: The positions refer to the reference point:
Positioning angle for machining surface
Reference point Y
Reference point Z
Reference point X
Width of spigot
Length of spigot
Corner radius
Depth relative to Z0 or X0 (inc) or spigot depth (abs) - (only for ∇ and ∇∇∇)
Maximum depth infeed – (only for ∇ and ∇∇∇)
Plane finishing allowance for the length (L) and width (W) of the rectangular spigot.
Smaller rectangular spigot dimensions are obtained by calling the cycle again and
programming it with a lower finishing allowance.
- (only for ∇ and ∇∇∇)
Depth finishing allowance (tool axis) - (only for ∇ and ∇∇∇)
Width of blank spigot (important for determining approach position) - (only for ∇ and
∇∇∇)
Length of blank spigot (important for determining approach position) - (only for ∇
and ∇∇∇)
Chamfer width for chamfering - (for chamfering only)
Insertion depth of tool tip (abs and inc) - (for chamfering only)
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
mm
mm
mm
mm
mm or
degrees
mm
Degrees
mm
mm or
degrees
mm
Degrees
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
Turning