6.9.5
Defining cutting planes
In the 3D view, you have the option of "cutting" the workpiece and therefore displaying
certain views in order to show hidden contours.
Precondition
The simulation or the simultaneous recording is started.
Procedure
...
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
1.
Press the "Details" softkey.
2.
Press the "Cut" softkey.
The workpiece is displayed in the cut state.
3.
Press the corresponding softkey to shift the cutting plane in the required
direction.
6.9 Editing and adapting a simulation graphic
Simulating machining
213