Siemens SINUMERIK 828D Operating Manual page 252

Creating a ShopTurn program
8.6 Program header
Parameter
Spindle chuck data
Jaw type
ZC4
ZS4
ZE4
ZC3
ZS3
ZE3
XR3
ZR3
SC
S
Mach. direction of rota-
tion
Z3W
252
Description
Only chuck
•
You enter spindle chuck data in the program.
Complete
•
You enter tailstock data in the program.
Note:
Please observe the machine manufacturer's instructions.
Selecting the jaw type of the counterspindle. Dimensions of the front edge or
•
stop edge - (only if spindle chuck data "yes")
Jaw type 1
•
Jaw type 2
•
The main spindle chuck dimensions - (only for spindle chuck data "yes")
Stop dimension of the main spindle - (only for spindle chuck data "yes")
Jaw dimension of the main spindle for jaw type 2 - (only for spindle chuck data
"yes")
Chuck dimension of the counterspindle - (only for spindle chuck data "yes" and for
a counterspindle that has been set up)
Stop dimension of the counterspindle - (only for spindle chuck data "yes" and for a
counterspindle that has been set up)
Jaw dimension of the counterspindle with jaw type 2 - (only for spindle chuck data
"yes" and for a counterspindle that has been set up)
Tailstock diameter - (only for spindle chuck data "complete" and tailstock that has
been set up)
Tailstock length - (only for spindle chuck data "complete" and tailstock that has
been set up)
The safety clearance defines how close the tool can approach the workpiece in
rapid traverse.
Note
Enter the safety clearance without sign into the incremental dimension.
Spindle speed (maximum main spindle speed)
If you want to machine the workpiece with a constant cutting rate, the spindle
speed must be increased as soon as the workpiece diameter becomes smaller.
Since the speed cannot be increased at will, you can set a speed limit for the main
spindle (S1) and for the counter-spindle (S3), depending on the shape, size, and
material of the workpiece or collet.
The machine manufacturer only sets one speed limit for the machine, i.e. none
that are dependent on the workpiece.
Please refer to the machine manufacturer's specifications.
Milling direction
Conventional milling
•
Climbing
•
Machining position of the counter spindle in the MCS.
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Unit
mm
mm
mm
mm
mm
mm
mm
mm
rev/min
mm
Turning