Siemens SINUMERIK 828D Operating Manual page 620

Multi-channel machining
10.2 Multi-channel support
Parameter
ZI
ZB
N
SW or L
W
L
S
Spindle chuck
data
Spindle chuck
data
ZC
ZS
ZE
Counter-spindle
Spindle chuck data
Spindle chuck data
620
Description
Final dimension (abs) or final dimension in relation to ZA (inc)
Machining dimension (abs) or machining dimension in relation to ZA (inc)
Number of edges – only for polygon
Width across flats or edge length – only for polygon
Width of the blank - only for centered cuboid
Length of the blank - only for centered cuboid
Speed limitation of the main spindle
Yes
•
You enter spindle chuck data in the program.
No
•
Spindle chuck data is transferred from the setting data.
Note:
Please observe the machine manufacturer's instructions.
Only chuck
•
You enter spindle chuck data in the program.
Complete
•
You enter tailstock data in the program.
Note:
Please observe the machine manufacturer's instructions.
The main spindle chuck dimensions - (only for spindle chuck data "yes")
•
Stop dimension of the main spindle - (only for spindle chuck data "yes")
•
Jaw dimension of the main spindle for jaw type 2 - (only for spindle chuck data
•
"yes")
Yes
•
You enter spindle chuck data in the program.
No
•
Spindle chuck data is transferred from the setting data.
Note:
Please observe the machine manufacturer's instructions.
Only chuck
•
You enter spindle chuck data in the program.
Complete
•
You enter tailstock data in the program.
Note:
Please observe the machine manufacturer's instructions.
•
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Unit
mm
mm
mm
mm
rev/min
mm
mm
mm
Turning