Siemens SINUMERIK 828D Operating Manual page 634

Multi-channel machining
10.2 Multi-channel support
Parameter
Tool change point
XT
ZT
S
SC
Mach. direction of rotation Milling direction
Changing program settings
Under settings, the settings for the main and/or counterspindle can be changed while the
program is being executed.
Parameter Description
Data for You define the spindle selection for processing the data here - (this is only available if
the machine has a counterspindle)
Main spindle
•
Data set for the main spindle
Counterspindle
•
Data set for the counterspindle
Main+counterspindle
•
All values for the main and counterspindle are saved in one data set
Retraction Lift mode
simple
•
Extended
•
all
•
Empty
•
XRA Retraction plane X external ∅ (abs) or retraction plane X referred to XA (inc)
XRI Retraction plane X internal ∅ (abs) or retraction plane X referred to XI (inc)
- (only for retraction "extended" and "all")
634
Description
Tool change point, which must be approached by the revolver with its zero point.
WCS (Workpiece Coordinate System)
•
MCS (Machine Coordinate System)
•
Notes
The tool change point must be far enough outside the retraction area that it
•
is not possible for any tool to protrude into the retraction area while the re-
volver is moving.
Ensure that the tool change point is relative to the zero point of the revolver
•
and not the tool tip.
Tool change point X ∅
Tool change point Z
Spindle speed
The safety clearance defines how close the tool can approach the workpiece in
rapid traverse.
Note
Enter the safety clearance without sign into the incremental dimension.
Conventional
•
Climbing
•
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Unit
mm
mm
rev/min
mm
Unit
mm
mm
Turning