Siemens SINUMERIK 828D Operating Manual page 550

Programming technology functions (cycles)
9.5 Contour milling
Parameters in the "Input simple" mode
G code program parameters
Input
PRG Name of the program to be generated
Milling direction
•
•
RP Retraction plane
F Feedrate
Parameter
Machining
surface
(only for ShopTurn)
(only for ShopTurn)
Machining
Z0
Z1
CP
(only for ShopTurn)
C0
(only for ShopTurn)
DXY
DZ
UXY
550
simple
•
Climbing
Conventional
mm
*
Description
Face C
•
Face Y
•
Face B
•
Peripheral surface C
•
Peripheral surface Y
•
Clamp/release spindle (only for end face Y/B and peripheral surface Y)
The function must be set up by the machine manufacturer.
The following machining operations can be selected:
∇ (roughing)
•
∇∇∇ base (base finishing)
•
∇∇∇ edge (edge finishing)
•
Chamfering
•
Reference point in the tool axis Z
Pocket depth (abs) or depth referred to Z0 (inc)
Positioning angle for machining area - (only for machining surface, face Y)
Positioning angle for machining area - (only for machining surface, peripheral
surface Y)
Maximum plane infeed
•
Maximum plane infeed as a percentage of the milling cutter diameter- (only
•
for ∇ and ∇∇∇ base)
Maximum depth infeed - (only for ∇ and ∇∇∇ edge)
Plane finishing allowance – (only for ∇, ∇∇∇ base and ∇∇∇ edge)
ShopTurn program parameters
T Tool name
D Cutting edge number
F Feedrate
S / V Spindle speed or constant
cutting rate
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
mm/min
mm/rev
rpm
m/min
mm
mm
Degrees
Degrees
mm
%
mm
mm
Turning