Siemens SINUMERIK 828D Operating Manual page 604

Programming technology functions (cycles)
9.7 Additional cycles and functions in ShopTurn
Note
You can withdraw the blank several times successively without parting in order to continue
the machining on the same side.
Parameter
Function
Workpiece transfer
Complete transfer
function
Coordinate
system
XP
ZP
Flush chuck
DIR
Clamping
S
α1
Z1
ZR
FR
604
Description
You can select between five different functions:
Complete transfer
•
Gripping
•
Withdrawing
•
Machining side
•
Main spindle in counter-spindle
•
Counter-spindle in main spindle
•
Gripping
Machine coordinate system (MCS)
•
The park position is specified in the machine coordinate system. Teaching
in the park position and angular offset is only possible in the machine coor-
dinate system.
Workpiece coordinate system (WCS)
•
The park position is specified in the workpiece coordinate system.
Park position of tool in X direction (abs)
Park position of tool in Z direction (abs)
Flush counter-spindle chuck
Yes
•
No
•
Direction of rotation
Spindle rotates clockwise
•
Spindle rotates counter-clockwise
•
Spindle does not rotate
•
Clamping both spindles (only if spindles are not turning)
•
Clamping open
•
Clamping closed
Spindle speed – (only when the spindle rotates)
Angular offset
Transfer position (abs.)
Position, feedrate reduction (abs or inc)
Position from which a reduced feedrate is used.
Reduced feedrate
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Unit
mm
mm
rev/min
Degrees
mm/rev
Turning