Siemens SINUMERIK 828D Operating Manual page 517

Cartesian starting point
Polar starting point
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
1. Enter the starting point for the contour.
2. Enter any additional commands in G code format, as required.
3. Press the "Accept" softkey.
4. Enter the individual contour elements.
1. Press the "Pole" softkey.
2. Enter the pole position in Cartesian coordinates.
3. Enter the starting point for the contour in polar coordinates.
4. Enter any additional commands in G code format, as required.
5. Press the "Accept" softkey.
6. Enter the individual contour elements.
Programming technology functions (cycles)
9.5 Contour milling
517