Copying/Pasting/Deleting A Program Block - Siemens SINUMERIK 840D sl Operating Manual

Machining the workpiece
3.9 Editing a program
3.9.4

Copying/pasting/deleting a program block

Requirement
The program is opened in the editor.
Procedure
Deleting program blocks
Note
The buffer memory contents are retained even after the editor is closed, enabling you to
paste the contents in another program, as well.
110
1. Press the "Mark" softkey.
- OR -
Press the "SELECT" key.
2. Select the desired program blocks with the cursor or mouse.
3. Press the "Copy" softkey in order to copy the selection to the buffer
memory.
4. Place the cursor on the desired insertion point in the program and
press the "Paste" softkey.
The content of the buffer memory is pasted.
Use the "Cut" softkey to delete selected program blocks.
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
HMI sl Turning